Share your CCIE v5 Written Experience

@Everyone

thank goodness CC is back!

hello， everybody
spoto just update the newest ccie rs today with 242 Q

Hi Any body looking to do CCIE Lab (R&S) Join group on Skype with me for a cheap bargain for all updated material.

Does spoto have explanations with their answers?

Yes we are back.

Say bye bye to copy cat sites and visit the original certcollection.org and do say hello to the original Glavin 😀

https://certcommunity.org/forum/ what a bunch of opportunistic fcuks. get lost!
the real cc is up and running that too with intact DB.

certcollection.org went online guys.

it’s a trap!!!!!

what trap?

hello

CCIE Kam i am not understand what you say. sorry my bad english.
my friend roche failed he using spoto and 591. many new questions.

many guys fail the exam with spoto old dump with 156 Q
but spoto just update the newest one is 240 Q

You will have prosperous future if you have Certification in CISCO CCNP… Visit our website for getting any exam guide related CISCO: http://www.braindumpskey.com/exam/300-115.html

Does spoto give explanations with their answers?

Hello folks ,

I just attempted the exam couple of hours back and failed with 792 marks , passing marks were 804 🙁
exam had almost 70-80% questions out of the dumps ,
i had used 109 corrected , 119 , PL325 , PL270 , and believe me at least 70-80% questions were missing in these..

i don’t recall the exact questions but there were questions about
IOS-XE
PPPoE drag and Drop
question about MRU

Hey, would you mind to take a look at this doc just for the sake of confirmation. I just got it from a source.

https://www.4shared.com/postDownload/pvdcnpjRei/RNS_WRITTEN_-_01-JUNE-17.html

@ ccierack

Dear its old version used for exam before 25th May 2017.
i did not find any new question in the above version but i think some one change the header as 01-Jun-2017 and in actual its not the new version so wait at least few days.

Good Luck

1. DRAG AND DROP: FEASIBLE DISTANCE, FEASIBLE SUCCESSOR AND REPORTED DISTANCE.
2. DRAG AND DROP: PAGP vs LACP
3. pap authentication, vitual-template on a disgram. question. find fault? (not the one in 311q)
4. uldp in layer 2 mpls xconnect. two PE routers connected two CE. question that if PEs rebooted what is the effect on the virtual circuit
5. along the part of a packet to it destination. which qos service can change (different option like ip presedence, dscp, code etc
6. control plane policing on a router. matching access-list that deny a segment of network and permit all. question was based on access right.
7. Question on logg display on console and telnet
8. question on 4 P-routers connected to 2PE router and 2CE router.
9. redistributing a default static route into ospf. (options: retribute static, redistribu static subnet, defult information originate)
10. access-list that allows only service to icmp unreachable. question on traceroute.
11. can’t remember vividly but question on autoRP. (option: dense, spare , loopback etc)
12. question with diagram on ospf type1. total stuby (not the one in 311q)
13. similar questions in q311 but completely different options.

ok… thanks…

do not give exam for few week. i suggest to all. give exam if you are rich

@june

u mean when we become billionaire then attempt exam 🙂

HI guys ,firstly thanks for spoto ccie club, i share the feedback of ccie h2 + cfg
there are two feedbacks : CCIE RS H2 + CFG

=====================DIAG H3+++========================

same as the SPOTO DIAG H3 +++

=======================H2+ =========================

1. Almost 99% are the same as SPOTO V1.6
2. exam require the R11/12/13/14 show ip bgp 10.0.0.0/8 is 65001 to 65002
so must set the PE(R11-R16) EBGP neighbor allowas-in

=================TS2============================
Q1
User 4 no ip address client-id e0/0..
SW5400/401 ospf passive vlan remove it
R40 ip dhcp pool lease 0 2 change or removie it

Q2. SW111 add server 1 vlan into ospf

Q3. R12 change route-map set originate to igp
R22/23 modify route-map access-list 1 & 2to right

Q4. exam require route path Server2 to R41, and R41 to Server2
change R20/21 route-map LP. increase the R21 MED

Q5 R15 add SW111 OSPFV3 vlan network into BGP ipv6

@CCIE_Olx, how can I contact you?

@CCIE_Olx no. yor are funny. i mean let dump get stable. when stable then give exam. if not then we loose 400 dollar. i m not rich 🙁
my friend roche lost 400 dollar he failed. now no more money to give again. so he wait for gather money.

@Shikima what do you mean by that?

@ted

he was talking about https://certcommunity.org/
suckers shut it down after cc.org came online.
i hope no user from cc.org registered to the fake forum with their cc.org password. if yes, then kindly change your cc.org password.

@Ted & ciscoguy, both can be used to check your email and info to remove your certifications, be careful

@ciscoguy Ah, okay. I thought that he meant the real cc.org was now a trap. 🙂

@Shikima, okay now I am getting confused. Not unusual but I am. 🙂

i clear it with spoto 240 dump

www.spoto.net

cciersspotonet

can someone tell me spoto website

http://ccierss.spoto.net

i use spoto 240 dumps and clear it
thanks
http://shop.spoto.net

How To Prepare Free Cisco 400-101 Dumps Question Answers
Subscribe Education Certifications Channel And Share: https://youtu.be/QsodE4SH8-8

Dear All

who are interested in 400-101 written exam. i have purchased dumps which are latest and new questions are 239.
if you are intersted in sharing. please email me.
alishabbir135 @ yahoo . com

Looks like PL have updated their 400-101 on Jun 2. Has anyone got the latest version? Pls share..

PL updated on June 2nd, can someone please share if they have it. Thanks.

@Alishabbir, what dumps you are referring to ? spoto or pl or pcl?

PL DID NOT update on June 2nd – although their web site says they did. You can trust me on this. They say their update will be complete in 2-3 weeks.

My experience in the past – Spoto is faster – but they have wrong answers and are much more expensive. PL slower, but better answers.

@Cat and Mouse, Thanks for the update. So it’s advisable to wait till this time. I think I will wait for PL to update in 2-3 weeks.

@all CCIE aspirants,
While we try to use dumps for the exams, please let’s also strive to study hard and learn all topics on the 400-101 blueprint very well; my friend who is now a ccie said it will help while preparing for the lab exams.

Good Luck to all!

@ CCIE RnS Written
What about 591lab?

@anybody have new PL325

i am refering to spoto

please what is correct answer:

You are configuring Routerl and Router2 for L2TPv3 tunneling. Which two additional configuration

are required to enable Router 1 and Router2 to establish the tunnel? (Choose 2)

A, An IP address must be configured on interface FastEthernet1/O on Router 1.

B. Cisco Discovery Protocol must be enabled on interface FastEthernet1/O on Router 1.

C. Loopback O on Routerl must be advertised to Router2.

D. Routerl must be configured to encapsulate traffic by using L2TPv3 under the pseudowire-class RitoR2.

E, Cisco Express Forwarding must be disabled on Routerl.

Refer to the exhibit. Which two conclusions can you draw from this output(choose two)
A. The device at the 192.168.5.119 routing table has an APR entry for the device at 10.9.132.254.
B. The packet was source-routed.
C. The device at 192.168.5.119 is on the same subnet as the next -hop for the device at 10.9.132.254.
D. The device that produced the output uses different interfaces to send and receive traffic to and from the device at 10.9.132.254
E. The device that produced the output uses the same interface to send and receive traffic to and from the device at 10.9.132.254

@ccie_olx
The answers to the L2TPv3 q are C and D.

the encapsulation ( L2TPv3) needs to be configured under the interface and L0 address needs to be accessible from the core.

cc is going offline again 🙁

what is answer

Which tag will be applied to the 172.16.130.0/24 route?

A. 10

B. 20

c. 30

D. 40